Lenze E84DSxxx - Manual (Page 473)

Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
473
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00002/14 0: Off / ready Reserved
C00002/15 0: Off / ready Reserved
C00002/16 1: On / start Enable controller
"1" ≡ Enable controller
"0" ≡ Inhibit controller
C00002/17 0: Off / ready Activate quick stop
"1" ≡ Activate quick stop
"0" ≡ Deactivate quick stop
C00002/18 0: Off / ready Reserved
C00002/19 0: Off / ready Reset error
• After the reset (acknowledgement) of the current
error, further errors may be pending which must also
be reset.
• The status determining error is displayed in C00168 .
• The current error is displayed in C00170 .
C00002/20 0: Off / ready Reserved
C00002/21 0: Off / ready Delete logbook
• All entries in the logbook of the controller are deleted.
• In the logbook, information on the error history is
saved.
C00002/22 0: Off / ready Reserved
C00002/23 0: Off / ready Identify motor parameter (ASM)
• This device command serves to carry out automatic
motor parameter identification.
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
• In order to identify the motor parameters, the
controller must be enabled after this device
command.
 Automatic motor parameter identification
C00002/24 0: Off / ready Reserved
C00002/25 0: Off / ready Reserved
C00002/26 0: Off / ready CAN reset node
• Reinitialise "CAN on board" interface.
• Required when changing the baud rate, node address,
or identifiers.
 "CAN on board" system bus
C00002/27 0: Off / ready Device search function
• From version 06.00.00
• This device command serves to optically locate a
controller connected online (e.g. for maintenance
work).
 Device search function
C00002/28 0: Off / ready Check MasterPin
• From version 06.00.00
 Unlocking the controller with a MasterPin
C00002/29 0: Off / ready Set binding ID
• From version 06.00.00
 Device personalisation
C00002/30 0: Off / ready Delete binding ID
• From version 06.00.00
 Device personalisation
C00002/31 0: Off / ready Set password
• From version 06.00.00
 Password protection
Parameter | Name:
C00002 | Device command
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h