Lenze E84DSxxx - Manual (Page 95)

Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
95
4 Device control (DCTRL)
4.4 Internal interfaces | "LS_DriveInterface" system block
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
bInit
BOOL
TRUE " Init " device state is active
bSafeTorqueOff
BOOL
TRUE " SafeTorqueOff " device state is active
bReady
BOOL
TRUE " SwitchedOn " device state is active
bReadyToSwitchOn
BOOL
TRUE " ReadyToSwitchOn " device state is active
bOperationEnable
BOOL
TRUE " OperationEnabled " device state is active
bWarning
BOOL
TRUE A warning is indicated
bTrouble
BOOL
TRUE " Trouble " device state is active
bFail
BOOL
TRUE " Fault " device state is active
bCollectedFail
BOOL
TRUE Group error: A device status according to the group error
configuration in C00148 has occurred, the drive is not able to follow
the setpoint selection.
bSafetyIsActive
BOOL
TRUE In preparation
bImpIsActive
BOOL
TRUE Pulse inhibit is active
bCInhIsActive
BOOL
TRUE Controller inhibit is active
bCwCcw
BOOL
FALSE Motor rotates in CW direction
TRUE Motor rotates in CCW direction
bNactCompare
BOOL
TRUE During open-loop operation:
Speed setpoint < Comparison value ( C00024 )
During closed-loop operation:
Actual speed value < Comparison value ( C00024 )
Identifier
DIS code | data type
Value/meaning