Lenze E84DSxxx - Manual (Page 48)

3 Commissioning
3.7 Commissioning of the "Actuating drive speed" technology application
48
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.7.2 Creating an »Engineer« project & going online
The following steps serve to describe a general method for creating a project with the Select
component from catalogue option. For this purpose, individual components (controller, motor, etc.)
are selected from selection lists.
1. Start the »Engineer«.
2. Create a new project with the Start-up wizard and the Select component from catalogue option:
• In the Component step, select the 8400 protec StateLine controller.
• Select the available communication and safety system in the Device modules dialog step.
• In the Application step, select the "Actuating drive speed" application. (The application can
also be selected any time afterwards via the Application parameter tab or C00005 .)
• In the Other components step, select other components (motor / gearbox) to be added to the
project.
3. Go online.
• After a connection to the controller has been established, the following status is displayed in
the Status line:
4. If the controller is enabled: Inhibit controller.
5. Transfer parameter set to the device.
• This command serves to overwrite the current parameter settings in the controller by
parameter settings of the »Engineer« project.

You can find detailed information on the general use of the »Engineer« in the online help
which you can call with [F1].
• The chapter "Working with projects" describes, among other things, all options of the
Start-up wizard which are available to create a new »Engineer« project.