Lenze E84DSxxx - Manual (Page 309)

Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
309
8 Basic drive functions (MCK)
8.4 Holding brake control
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of parameters for holding brake control:
8.4.2.1 Operating mode
For different applications and tasks, different operating modes are available in C02580 . The
selected operating mode determines whether the holding brake control is used and how the
holding brake will be switched.
Mode 0: Brake control off
In this mode, brake control is switched off (not active).
• The bBrkReleaseOut trigger signal for the holding brake control switching element is set to
FALSE.
• The bBrkReleased status signal is set to FALSE.
Parameter Info Lenze setting
Value Unit
C02580 Holding brake: Operating mode 12: Autom. controlled
C02581/1 Holding brake: Switching threshold 5.00 %
C02581/2 Holding brake: Hyst. release 1.00 %
C02581/3 Holding brake: Hyst. close 1.00 %
C02582 Holding brake: Setting 0
C02589/1 Holding brake: Closing time 100 ms
C02589/2 Holding brake: Release time 100 ms
C02589/3 In preparation - without function at the moment!
Holding brake: Waiting time status
100 ms
C02593/1 Holding brake: Actual value monitoring 0.000 ms
C02610/1 MCK: Holding brake ramp time synchr. 2.000 s
C02607 Holding brake: Status -
C00830/68 MCK: nBrkAddValue_a - %
C00833/80 MCK: bBrkRelease -
C00833/81 MCK: bBrkStartValue2 -
C00833/82 MCK: bBrkApplied -
Highlighted in grey = display parameter