Lenze E84DSxxx - Manual (Page 460)

14 Parameter change-over
14.2 Configuring the list using the »Engineer« parameterisation dialog
460
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Outputs
14.2 Configuring the list using the »Engineer« parameterisation dialog

Proceed as follows to open the dialog for parameterising the parameter change-over:
1. »Engineer« Go to the Project view and select the 8400 protec StateLine controller.
2. Select the Application parameters tab from the Workspace.
3. Go to the Overview dialog level and click the "basic functions" button.
4. Go to the Overview  Basic functions dialog box and click the Parameter change-over
button.
Identifier
Data type
Value/meaning
bDone
BOOL
"Writing of the parameter list completed" status signal
• The output is automatically reset to FALSE if writing via bExecute is activated
again.
TRUE Writing of the parameter list successfully completed.
FALSE The FALSE status can have the following meanings:
1.There is no active writing of the parameter list.
2.Writing of the parameter list has not been completed yet.
3.An error has occurred (if bFail = TRUE).
bFail
BOOL
"Error" status
TRUE An error has occurred (group signal).
• For details see display parameter C01083 .