Bio-Rad EXQuest Spot Cutter - Manual (Page 495)

PDQuest User Guide
J-4
3. Select the resolution.
4. Acquire the image.
J.2 Step I. Select Application
In Step 1, you select the appropriate filters and other scanning parameters for the type
of gel, blot, plate, or other object that you are imaging. Each set of parameters you
select is called an “application.”
The FX now supports multi-channel sequential scanning. This allows you to
automatically scan the same object using up to four different applications (e.g., to
detect different types of stains on the same gel).
First you select a channel, then you select the application under that channel.
J.2.a Selecting a Channel
The four channels are accessed using the tabs under Step 1. Channel 1 is always
enabled—that is, the FX will always scan using the application settings selected
under Channel 1 first.
To enable any of the remaining channels, click on a channel tab, then select the
Enable Channel checkbox and select the application for that channel as described in
the following section.