Yaskawa MP2300S Basic Module - Manual (Page 101)

3.1 Mounting MP2300S
3.1.4 Replacing and Adding Optional Modules
3-10
3.
Remove the Optional Module from the mounting base.
Pull the top of the panel of the Optional Module towards you to remove it. A notch on the Optional Module will
be visible from the gap in the cover. Hook the round knob on the battery cover, shown in the diagram, into the
notch in the Optional Module.
Hold the center of the battery cover as shown in the following diagram. Push the battery cover down and out,
rotating from the round knob to disconnect the Module and mounting base connectors, and then pull the Optional
Module forward.
4.
Pull out the Optional Module.
Hold the Module on the top and bottom and pull it out straight. Hold the edges of the Module and avoid touching
the parts on the Module.
Put the removed Module into the bag that was supplied with and store the Module in this bag.
Notch
Round knob
Fulcrum
Turn