Yaskawa MP2300S Basic Module - Manual (Page 437)

Appendix G MSG-SND/MSG-RCV Functions (Ethernet)
G.2 Message Receive Function (MSG-RCV)
A-115
Appendices
( 2 ) When Writing
Data flow when writing
Write range LO
Write range HI
MW00000
MW
Data address B
Offset A
Data size C Data
M register
MP2000 series (reception: slave) Remote device (transmission: master)
Data size C Data
Start address of
the write data
[MSG-RCV function]
Communication protocol = MEMOBUS
Parameter list
PARAM00
PARAM01
:
PARAM08
PARAM09
PARAM10
PARAM11
PARAM12
PARAM13
:
PARAM16
Offset A
Write range
[MSG-RCV function]
Communication protocol = non-procedure
Parameter list
PARAM00
PARAM01
:
PARAM08
PARAM09
PARAM10
PARAM11
PARAM12
PARAM13
:
PARAM16
Offset A
Write range
♦ Transmission side sets the data address B and the data size C.
♦ In case of non-procedure, write cannot be received.
♦ The valid offset parameter may differ according to each data type.
♦ The data type and register correspond as follows:
Coil: MB , holding register: MW