A-83, 2 ) when writing – Yaskawa MP2300S Basic Module User Manual
Page 405
Advertising
Appendix G MSG-SND/MSG-RCV Functions (Ethernet)
G.1 Message Transmit Function (MSG-SND)
A-83
Appendices
( 2 ) When Writing
Fig. G.6 Data Flow when Writing
Fig. G.7 Parameter Setting
MW00000
MWxxxxx
Offset A
Data address B
Data size C
Data
M register
Coil and holding registers
MP2000 series (transmission: master)
Remote device (reception: slave)
Data address B
Data size C
Data
Start address of the
write data source
The data type of the remote
device is not determined
in non-procedural protocol mode.
Note:
[MSG-SND function]
Parameter list
PARAM00
PARAM01
:
PARAM05
PARAM06
PARAM07
PARAM08
PARAM09
PARAM10
PARAM11
:
PARAM16
Data address B
data size C
Offset A
Valid parameter may differ, depending on the function code and
communication protocol used.
Advertising