Yaskawa MP2300S Basic Module - Manual (Page 62)

2.2 Basic Module
2.2.5 Built-in SVB Module
2-36
Servo Cont
ro
l
Communication Method
Single-send (communication cycle = transmission cycle) synchronous communication
Transmission/communication error detection (hardware) provided.
Synchronous communication error detection (software) provided.
Automatic recovery function not provided (recovery when alarm is cleared).
I/O Registers Input/output using motion registers (synchronized on high-speed scan)
Command Mode Motion Command Mode/MECHATROLINK Transparent Command Mode
Supported Servomotors Standard motors, linear motors, and direct-drive motors
Control Type Position control, speed control, torque control, and phase control
Motion Commands
Positioning, External Positioning, Zero Point Return, Interpolation, Interpolation with Posi-
tion Detection, JOG operation, STEP operation, Speed Reference
* , Torque Reference * ,
Phase Control * , etc.
Acceleration/Deceleration
Method One-step asymmetric trapezoidal acceleration/deceleration, exponential acceleration/decel-
eration filter, moving average filter
Position Unit pulse, mm, inch, degree, μm
Speed Unit
Reference units/s, 10
n
reference units/min, percentage of rated speed
Acceleration Unit Reference units/s 2 , ms (acceleration from 0 until rated speed reached)
Torque Unit Percentage of rated torque
Electronic Gear Provided.
Position Control Method
Finite length position control, infinite length position control, absolute system infinite length
position control, and simple absolute system infinite length position control
Software Limit Positive/negative direction for each point
Zero Point Return Method 13 types
SERVOPACK Parameter
Management
Parameters can be managed in the MPE720’s SERVOPACK Parameter Window.
Inv
e
rter Cont
rol
Communication Method
Single-send (communication cycle = transmission cycle) asynchronous communication
Transmission/communication error detection (hardware) provided.
Synchronous communication error detection (software) not provided.
Automatic recovery function not provided (recovery when alarm cleared).
I/O Registers Input/output using motion registers (synchronized on high-speed scan)
Command Mode Motion Command Mode/MECHATROLINK Transparent Command Mode
Control Type Speed control only (V/F, vector control and other control methods use inverter settings.)
Motion Commands Inverter I/O control, etc.
Speed Unit The speed unit depends on the inverter settings.
I/
O C
on
tro
l
Communication Method
Single-send (communication cycle = transmission cycle) asynchronous communication
Transmission/communication error detection (hardware) provided.
Synchronous communication error detection not provided.
Automatic recovery function provided.
I/O Registers
Input/output using I/O registers and synchronized on the high-speed scan or low-speed scan
(selectable).
Self-configuration Function Module and slave devices can be automatically allocated.
Synchronization between Modules
Synchronization supported (enabled when power is cycled) when high-speed scan cycle =
communication cycle times n
(cont’d)
Item Details
* Only with MECHATROLINK-II