Yaskawa MP2300S Basic Module - Manual (Page 213)

6.2 Communication with Other MP Series
6.2.2 When the MP2300S Acts as Slave (ladder program which uses a MSG-RCV function)
6-24
„
Parameter list setting example for message receive function
An example of a parameter list setting when receiving messages from a transmit source using the connection with
a connection number = 2 follows:
Note: IN: Input, OUT: Output, SYS: For system use
Table 6.5 Parameter List Setting Example (parameter list start address Param=DA00000)
Register
Number
Setting
Value
Parameter
Number
IN/OUT Remarks
DW00000 – PARAM00 OUT Process result
DW00001 – PARAM01 OUT Status
DW00002 00002 PARAM02 IN Connection number = 2
DW00003 – PARAM03 OUT Option
DW00004 – PARAM04 OUT Function code
DW00005 – PARAM05 OUT Data address
DW00006 – PARAM06 OUT Data size
DW00007 – PARAM07 OUT Remote CPU number
DW00008 00000 PARAM08 IN Coil offset = 0 word
DW00009 00000 PARAM09 IN Input relay offset = 0 word
DW00010 00000 PARAM10 IN Input register offset = 0 word
DW00011 00000 PARAM11 IN Holding register offset = 0 word
DW00012 00000 PARAM12 IN Writable address lower limit = MW00000
DW00013 65534 PARAM13 IN Writable address upper limit = MW65534
DW00014 – PARAM14 SYS Reserved by the system. (Zero clear at startup)
DW00015 – PARAM15 SYS Reserved by the system.
DW00016 – PARAM16 SYS Reserved by the system.