Yaskawa MP2300S Basic Module - Manual (Page 175)

5.4 Self-configuration
5.4.1 How to Execute Self-Configuration
5-42
5.4.1 How to Execute Self-Configuration
The following two methods are available for executing the self-configuration.
• Execute the self-configuration (from DIP switch)
• Execute the self configuration (from MPE720)
Now, this section explains each way to execute the self-configuration.
( 1 ) Procedure Using the DIP Switch
Self-configuration can be executed from the Basic Module DIP switch.
[ a ] When Executing the Self-Configuration First Time after Connecting Equipment
By performing the operation below, the self-configuration for all modules is newly executed, and all new definition
files are created.
Before performing the operation, turn ON the power supply of equipment such as SERVOPACK.
„ Caution
Note that this operation can clear the following data in MP2300S.
• All definition files, all user programs, and all registers
1. Turn OFF the power supply.
Turn OFF the 24-VDC power supply to the MP2300S. ޓ
2. Set the DIP switch.
Set the switches INIT and CNFG of the DIP switch SW1 on the MP2300S
Basic Module to ON.
ޓ
3. Turn ON the power supply.
Turn ON the 24-VDC power supply to the MP2300S.
4. Check the LED indicators.
Check that the LED indicators on the MP2300S Basic Module change as
follows.
5. Reset the DIP siwtch.
Set the switches INIT and CNFG of the DIP switch SW1 on the MP2300S
Basic Module to OFF. ޓ
STOP
SUP
INIT
CNFG
MON
TEST
STOP
SUP
INIT
CNFG
MON
TEST
RDY
ALM
MTX
TRX
RUN
ERR
BAT
IP
RDY
ALM
MTX
TRX RUN
ERR
BAT
IP
RDY
ALM
MTX
TRX RUN
ERR
BAT
IP
ڎ
ڎ : Lit : Unlit : Blinking