Yaskawa MP2300S Basic Module - Manual (Page 102)

3.1 Mounting MP2300S
3.1.4 Replacing and Adding Optional Modules
3-11
Mounting and Wiring
( 3 ) Installing Optional Modules
1.
Insert Optional Modules.
Hold the top and bottom of the Module to be installed, line up the Module on the left-side guide rail inside the
Option Slot, and then insert it straight.
ΠThe FG bar on the inside bottom of the Unit Case may be damaged if the Module is not inserted straight.
2. Mount on to the mounting base.
Once the Optional Module has been completely inserted, place your hand on the front face of the Optional Mod-
ule and push hard until the Optional Module has been inserted into the mounting base connectors. The front face
of the Optional Module and the hook will be aligned when the Optional Module has been installed properly.
3. Install the panel of the Optional Module.
Place the hole on the bottom of the panel of the Optional Module onto the hook on the bottom of the MP2300S.
Next, hook the hole at the top of the panel of the Optional Module onto the hook at the top of the MP2300S.
This completes the Optional Module mounting procedure.
Be sure to attach the optional cover (model: JEPMC-OP2300) on the empty slot.
Guide
rail