Canon imageCLASS D1650 All-in-One Monochrome Laser Printer - Manual (Page 85)

● To change the port number for multicast discovery, see Changing Port Numbers(P. 374) .
[Scope Name]
To include the machine into a specific scope, enter alphanumeric characters for the scope name.
3
Click [OK].
Notifying a device management software of the power status of the machine
1
Select [Sleep Mode Notification Settings] [Edit].
2
Select the [Notify] check box and specify the required settings.
[Notify]
Select the check box to notify a device management software of the power status of the machine. When
[Notify] is selected, you can expect the machine to avoid unnecessary communication during sleep mode
and reduce the total power consumption.
[Port Number]
Change the port number for this function according to the network environment.
[Number of Routers to Traverse]
Specify how many routers the notification packets can pass through.
[Notification Interval]
Specify how often the machine notifies a device management software of its power status.
3
Click [OK].
5
Restart the machine.
● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
◼ Configuring Settings for Communication between the Machine and Plug-ins
You can specify the settings to enable communication between the machine and imageWARE Enterprise Management
Console plug-ins. Use of plug-ins allows you to manage the machine's settings from imageWARE Enterprise
Management Console.
Setting Up
77