Grass Valley Kayak HD v.6.9.3 - Manual (Page 126)

126 Kayak — User Manual
Section 3 — Control Panels
Enabling and Disabling Bank Mode
The Bank mode in the E-MEM panel permits access to a stored snapshot or
timeline with a single button (hotkey). The bank number is the tens digit of
the register. The hotkeys are the units digits of the register. The Bank mode
may be enabled during storing but this does not have any particular ben-
efit.
Enabling Bank Mode
Hold the Bank key down and select the desired bank with the numeric
keypad. The Bank key lights up. In the display a B appears before the register
number.
Disabling Bank Mode
Press the lighting Bank button.
Selecting a Register While Storing
During the storing of snapshots or timelines the register to be used for
storage must be selected. The procedure is the same for both cases.
However, the indication in the display differs:
If the register number is to be taken over that was shown before the actua-
tion of the
Store or Edit button, no further selection is necessary.
During storing the contents of the register is overwritten.
If you wish to select the next free register, press the FREE button.
If you wish to select a particular register, enter a one- or two-digit number
with the numeric keypad. Errors can be deleted with
Clear .
Note Should the register be assigned, the contents is overwritten when storing.
Selecting a Register While Recalling
When a snapshot or a timeline is recalled, there are several ways to select a
corresponding register.
Example: snap b05 sn05 ----
For Snapshots STOR
For Timelines EDIT