Yaskawa MP930 - Manual (Page 180)

System Startup
4.3.10 Transferring Definitions, Parameters, and Programs
4 -78
J Transfer Procedure
The following screens show the transfer procedure for definitions, parameters, and programs.
1. Right click the XY-TABLE PLC folder, scroll down in order of Transfer (T) → All Trans-
fer (A) → All Load (HD → CPU) (L), place the cursor on All Load (HD → CPU) (L), and
click.
2. Registers do not need to be transferred, so turn OFF the register selection, and click OK
to start the transfer.
Click here.
4