Yaskawa MP930 - Manual (Page 304)

Command List
B -2
B.1 Motion Command List
The motion commands are listed in the following table.
Classification Command Name Programming Format Function/Meaning
Axis Move
Commands MOV POSITIONING MOV [axis1] − [axis2] − ⋅⋅⋅;
(Up to 14 axes can be desig-
nated.) Executes positioning at rapid traverse
speed for up to 14 axes simultaneously.
In programming, replace “−” with the nu-
merical data for each axis.
MVS LINEAR INTER-
POLATION MVS [axis1] − [axis2] − ⋅⋅⋅F−;
(Up to 14 axes can be desig-
nated.) Executes linear travel at interpolation feed
speed F for up to 14 axes simultaneously.
MCW
MCC
CLOCKWISE CIR-
CULAR INTER-
POLATION
COUNTERCLOCK-
WISE CIRCULAR
INTERPOLATION
MCW [axis1] − [axis2] − R−
F−; MCC [axis1] − [axis2] −
U− V− T− F−; Executes circular interpolation at tangential
speed F for two axes simultaneously fol-
lowing radius R (or designated center point
coordinates).
With the center point coordinate designa-
tion, multiple circles can be designated
with T−. (T− can also be omitted.)
MCW
MCC
CLOCKWISE HE-
LICAL INTER-
POLATION
COUNTERCLOCK-
WISE HELICAL IN-
TERPOLATION
MCW [axis1] − [axis2] −U−V−
[axis3] −T− F−;
MCC [axis1] − [axis2]
−R−[axis3] −F−; Moves three axes simultaneously in a com-
bination of circular interpolation and linear
interpolation outside of the circular inter-
polation plane. Speed F will be the circular
interpolation tangential speed.
With the center point coordinate designa-
tion, the number of turns can be designated
with T−. (T− can also be omitted.)
ZRN ZERO POINT RE-
TURN ZRN [axis1] − [axis2] − ⋅⋅⋅;
(Up to 14 axes can be desig-
nated.) Returns each axis to its zero point.
SKP SKIP SKP [axis1]− [axis2]− ⋅⋅⋅ SS−;
(Up to 14 axes can be desig-
nated.) If the SKIP signal turns ON during a linear
interpolation operation, skips the remain-
ing movement and proceeds to the next
block.
MVT SET TIME POSI-
TIONING MVT [axis1]− [axis2]− ⋅⋅⋅ T−;
(Up to 14 axes can be desig-
nated.) Executes positioning by clamping the feed
speed so that travel can be completed at the
designated time.
EXM EXTERNAL POSI-
TIONING EXM [axis1]− D−; When an external positioning signal is in-
put while external positioning is being
executed, only the travel distance desig-
nated by “D−” is positioned with an incre-
mental value, and then the next command
is executed.
B