Efficient Networks Siemens Sinamics S120 - Manual (Page 474)

Basic information about the drive system
12.2 Data sets
Drive Functions
474
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4
p0186[16] = p0186[17] = ... = p0186[23]
p0186[24] = p0186[25] = ... = p0186[31]
If this rule is not observed, alarm A07514 is output. If you need a precise representation of
the data set structure of the 611U, 32 drive data sets and 4 motor data sets must be
configured.
Examples for a data set assignment
Table 12-2 Example, data set assignment
DDS Motor
(p0186)
Encoder 1
(p0187)
Encoder 2
(p0188)
Encoder 3
(p0189)
DDS 0 MDS 0 EDS 0 EDS 1 EDS 2
DDS 1 MDS 0 EDS 0 EDS 3 -
DDS 2 MDS 0 EDS 0 EDS 4 EDS 5
DDS 3 MDS 1 EDS 6 - -
Copying a command data set
Set parameter p0809 as follows:
1. p0809[0] = Number of the command data set to be copied (source)
2. p0809[1] = Number of the command data to which the data is to be copied (target)
3. p0809[2] = 1
Start copying.
Copying is finished when p0809[2] = 0.
Note
In STARTER, you can copy the command data sets (Drive -> Configuration -> "Command
data sets" tab page).
You can select the displayed command data set in the relevant STARTER screens.
Copying a drive data set
Set parameter p0819 as follows:
1. p0819[0] = Number of the drive data set to be copied (source)
2. p0819[1] = Number of the drive data set to which the data is to be copied (target)
3. p0819[2] = 1
Start copying.
Copying is finished when p0819[2] = 0.