NORD Drivesystems BU0200 User Manual
Page 178
6 Parameterisation
BU 0200 GB-4411
Subject to technical alterations
177
Parameter
{Factory setting}
Setting value / Description / Note
Device
Supervisor
Parameter
set
P106
Ramp smoothing
(Ramp smoothing)
S
P
0 ... 100 %
{ 0 }
This parameter enables a smoothing of the acceleration and deceleration ramps. This is
necessary for applications where gentle, but dynamic speed change is important.
Ramp smoothing is carried out for every setpoint change. The value to be set is based on the set
acceleration and deceleration time, however values <10% have no effect.
The following then applies for the entire acceleration or deceleration time, including rounding:
100%
%
P106
P102
P102
TIME
ATION
ACCELER
tot
t
t
t
100%
%
P106
P103
P103
TIME
ON
DECELERATI
tot
t
t
t
P102
P103
Output
frequency
Desired
frequency
Time
each
10
– 100% of P102
each
10
– 100% of P103