NORD Drivesystems BU0200 - Manual (Page 243)

SK 200E Manual for frequency inverters
242 Subject to technical alterations BU 0200 GB-4411
6.3 Parameter overview, User settings
(P)

Depends on parameter set. These parameters can be set in various ways in the four parameter
sets.
[- xx]

Array parameter. A parameter can be set in various sub-groups.
S

Supervisor parameter, visibility depends on P003.
6.3.1 Overview of frequency inverter parameters
Parameter
No. [Array]
Name
Factory
setting
Super
visor
Setting after commissioning
P 1 P 2 P 3 P 4
OPERATING DISPLAYS (Section 6.1.1)
P000 Operating para. display
P001 Selection of display value 0
P002 Display factor 1.00 S
P003 Supervisor code 1
1 = All parameters visible except P3xx/P6xx
3 = all parameters visible
BASIC PARAMETERS (Section 6.1.2)
P100 Parameter set 0 S
P101 Copy parameter set 0 S
P102 (P) Acceleration time [s] 2.0
P103 (P) Deceleration time [s] 2.0
P104 (P) Minimum frequency [Hz] 0.0
P105 (P) Maximum frequency [Hz]
50.0
(60.0)
P106 (P) Ramp smoothing [%] 0 S
P107 (P) Brake reaction time [s] 0.00
P108 (P) Disconnection mode 1 S
P109 (P) DC brake current [%] 100 S
P110 (P) Time DC brake on [s] 2.0 S
P111 (P) P factor torque limit [%] 100 S
P112 (P) Torque current limit [%] 401 (off) S
P113 (P) Jog frequency [Hz] 0.0 S
P114 (P) Brake delay off [s] 0.00 S
P120 [-01]
External Control Units
BUS TB (Extension1)
1 (auto) S
P120 [-02]
External Control Units
BUS TB (Extension 2)
1 (auto) S
P120 [-03]
External Control Units
Setpoint TB (Extension 3)
1 (auto) S
P120 [-04]
External Control Units
Extension 4
1 (auto) S