NORD Drivesystems BU0200 - Manual (Page 251)

SK 200E Manual for frequency inverters
250 Subject to technical alterations BU 0200 GB-4411
Parameter
No. [Array]
Name
Factory
setting
Super
visor
Setting after commissioning
P 1 P 2 P 3 P 4
P543 [-03] (P) Actual bus value 3 9 S
P546 [-01] (P) Function Bus setpoint 1 1 S
P546 [-02] (P) Function Bus setpoint 2 0 S
P546 [-03] (P) Function Bus setpoint 3 0 S
P549 PotentiometerBox function 1 S
P550 EEPROM copy order 0
P552 [-01]
CAN master cycle [ms]
CAN Master function
0 S
P552 [-02]
CAN master cycle [ms]
CANopen abs. encoder
0 S
P555 P chopper limit [%] 100 S
P556 Braking resistor [Ω] 120 S
P557 Brake resistor type [kW] 0 S
P558 (P) Flux delay [ms] 1 S
P559 (P) DC run-on time [s] 0.50 S
P560 Mode of parameter save 1 S
POSITIONING (Section 6.1.7) NOTE: Further details are listed and described in Manual BU 0210. ( www.nord.com )
P600 (P) Position control 0 (off) S
P601 Actual position [rev] --- S
P602 Actual setpoint pos. [rev] --- S
P603 Current position diff. [rev] --- S
P604 Encoder type 0 S
P605 [-01]
Absolute value encoder
(multi)
10 S
P605 [-02]
Absolute value encoder
(single)
10 S
P607 [-01] Ratio (increment) 1 S
P607 [-02] Ratio (absolute) 1 S
P607 [-03] Ratio (setpoint/actual) 1 S
P608 [-01] Reduction ratio (increment) 1 S
P608 [-02] Reduction ratio (absolute) 1 S
P608 [-03]
Reduction ratio
(setpoint/actual)
1 S
P609 [-01] Offset position (incr.) [rev] 0 S
P609 [-02] Offset position (abs.) [rev] 0 S
P610 Setpoint mode 0 S
P611 Position controller P [%] 5 S
P612 Pos. Window [rev] 0 S
P613 [-01] Position 1 [rev] 0 S
P613 [-02] Position 2 [rev] 0 S
P613 [-03] Position 3 [rev] 0 S