4 parameterisation adapter sk epg-3h, 1 parameterisation adapter requirements, 2 using the parameterisation adapter – NORD Drivesystems BU0200 User Manual
Page 257
SK 200E Manual for frequency inverters
256
Subject to technical alterations
BU 0200 GB-4411
6.4 Parameterisation adapter SK EPG-3H
The SK EPG-3H parameterisation adapter is used as and interface between the plug-in EEPROM ("Memory
Module") and the parameterisation software for Windows
©
PCs "NORD CON". With this parameterisation
adapter it is possible
to save data sets from the Memory Module,
to edit individual parameters,
to load saved data records into the Memory Module
to convert the saved data record into a pdf file or
to compare the saved data set with an offline data set.
6.4.1
Parameterisation adapter requirements
Windows
©
– PC with NORD CON software Version 2.1 or higher
NORD CON control and parameterisation software is required for
processing and managing data. The "EPD" installation file is provided on
the CD which is supplied with the frequency inverter and the latest version
can be downloaded free of charge from our homepage.
USB hardware detection driver for SK PAR-3H and SK EPG-3H
The USB driver is saved on the PC on installation of the NORD CON 2.1
software. This USB driver is valid for the ParameterBox SK PAR-3H and the
parameterisation adapter SK EPG-3H. The driver can also be installed
separately.
1. Download the driver from:
and save it on a hard drive.
2. Connect the SK EPG-3H to a USB port (USB 2.0) with the enclosed
cable.
3. Installation of the device is performed automatically
(if necessary, search for new hardware under "Windows
©
Device Manager)
6.4.2
Using the parameterisation adapter
Step
Description
Comments
1
Ensure that the programming adapter is connected
to the PC.
2
Plug the memory module into the opening provided
in the programming adapter (allow to fully engage).