NORD Drivesystems BU0200 - Manual (Page 250)

6 Parameterisation
BU 0200 GB-4411 Subject to technical alterations 249
Parameter
No. [Array]
Name
Factory
setting
Super
visor
Setting after commissioning
P 1 P 2 P 3 P 4
P515 [-01]
CAN address
slave address
32
(dec)
S
P515 [-02]
CAN address
broadcast slave address
32
(dec)
S
P515 [-03]
CAN address *
Master address
32
(dec)
S
*) System bus
P516 (P) Skip frequency 1 [Hz] 0.0 S
P517 (P) Skip frequency area 1 [Hz] 2.0 S
P518 (P) Skip frequency 2 [Hz] 0.0 S
P519 (P) Skip frequency area 2 [Hz] 2.0 S
P520 (P) Flying start 0 S
P521 (P) Flying st. resolution [Hz] 0.05 S
P522 (P) Flying st. offset [Hz] 0.0 S
P523 Factory setting 0
P525 [-01] (P) Max. load monitoring 1 401 S
P525 [-02] (P) Max. load monitoring 2 401 S
P525 [-03] (P) Max. load monitoring 3 401 S
P526 [-01] (P) Min. load monitoring 1 0 S
P526 [-02] (P) Min. load monitoring 2 0 S
P526 [-03] (P) Min. load monitoring 3 0 S
P527 [-01] (P) Load monitoring, frequency 1 25 S
P527 [-02] (P) Load monitoring, frequency 2 25 S
P527 [-03] (P) Load monitoring, frequency 3 25 S
P528 (P) Load monitoring delay 2.0 S
P529 (P) Load monitoring mode 0 S
P533 Factor I
2
t motor [%] 100 S
P534 [-01] (P)
Torque disconnection limit [%]
Motor limit
401 (off) S
P534 [-02] (P)
Torque disconnection limit [%]
Generator limit
401 (off) S
P535 I 2 t motor 0
P536 Current limit 1.5 S
P537 Pulse disconnection [%] 150 S
P539 (P) Check output voltage 0 S
P540 (P) Mode phase sequence 0 S
P541 Set relay [hex] 0000 S
P542 [-01]
Set analog output [V]
first IOE
0.0 S
P542 [-02]
Set analog output [V]
second IOE
0.0 S
P543 [-01] (P) Actual bus value 1 1 S
P543 [-02] (P) Actual bus value 2 4 S