Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 114)

Publication 1758-UM002D-EN-P - October 2010
114 DataSite Flow Configuration Utility (DS FloConfig)
4. In the Timeout box, enter in milliseconds, the timeout duration for the
communication response to be received from the DataSite controller.
5. In the Try box, enter the maximum number of attempts for the
computer to connect to the DataSite controller.
6. Enter a password in the Password box.
This password is required for successful communication between the
computer and the DataSite controller, for example when setting and
saving parameter configurations.
The factory default setting for the password is 0000.
7. Click Apply.
The new settings are applied.
TIP
The factory default setting for the password in DataSite is
blank. This means you can enter any code in the Password
box to communicate with the DataSite controller.
IMPORTANT
To protect the configuration on the DataSite controller,
it is important to change the password. Without the
password, information can still be uploaded from the
controller, but downloads to the controller are forbidden.
For instructions on how to change the password, see
Change the Communication Password .