Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 245)

Publication 1758-UM002D-EN-P - October 2010
DataSite DNP3 Configuration Utility (DS DNP3) 245
Configure PC
Communication Settings PC communication parameter setting can be used to enable the writing of data
from the host computer to the DataSite controller while the host computer
can upload data from the DataSite controller according to the configuration at
the same time.
Configure the PC Communication
1. In the configuration tree of the DS DNP3 window, click the "+" symbol
next to Communication Settings.
The Communication Settings tree is opened.
2. Click PC Parameter.
The parameters for PC communications appear.
ATTENTION
Make sure that the PC communication parameters are set
correctly. Otherwise, communication between the PC and
the DataSite controller will not work.