Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 221)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 221
11 This bit can mean any of the following:
•Upper range value too high—Upper range value is greater than the upper sensor limit.
•Excess correction attempted—Correction attempted is outside of the permissible limits of the field device.
•In multidrop mode—When in multidrop mode, this command cannot be performed. The analog output is deactivated and
cannot be used when the polling address is set to a value within the range of 1…15.
•Invalid sensor type code—Sensor type code selected is not valid.
•Invalid sensor material code—Sensor material code selected is not valid.
•Invalid base volume units code—Base volume units code selected is not valid.
•Invalid base flow units code—Base flow units code selected is not valid.
•Flow rate set point too high—Value entered for the flow rate set point is too high.
•Density low limit too high—Value entered for the density low limit is too high.
•Access denied—Access to this part of the memory is not allowed.
•Invalid transmitter variable code.
•Invalid item number.
•Invalid wetted material code.
•Standard deviation too large.
•D2 too high—Value of the second density data is too high.
•Instrument in sample mode.
•Invalid calibration point.
•Flow rate factor too high.
•Invalid analog output HOLD code.
12 This bit can mean any of the following:
•Upper range value too low—Upper range value is less than the lower sensor limit.
•Invalid characterization—Characterization of the sensor is not valid.
•Invalid number of wires—Number of wires on the sensor is not valid.
•Invalid calibration point units code—Units code sent with the calibration point is not valid.
•Invalid calibration location code—Calibration location code selected is not valid.
•Invalid base time units code—Base time units code selected is not valid.
•Flow rate set point too low—Value entered for the flow rate set point is too low.
•Incorrect format—Format of the parameter entered is not correct.
•Density low limit too low—Value entered for the density low limit is too low.
•Write to ROM attempted—Writing of data to read-only memory is attempted.
•Invalid units code.
•Invalid sensor connection code.
•Invalid trim points units code—Units code sent with the trim point is not valid.
•Invalid trim location code—Trim location code selected is not valid.
•Invalid base mass time units.
•Invalid base volume time units.
•Standard deviation too small.
•Standard factor format.
First byte when bit 7 = 0 (Command Response) (Continued)
Bit Description