Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 74)

Publication 1758-UM002D-EN-P - October 2010
74 DataSite Configuration Settings Utility (DS Settings)
Load the HART Settings
This function enables you to load the HART settings previously saved in a file
buffer on the PC. This allows you to verify the settings while the DataSite
controller is offline.
Follow this step to load HART settings from the file.
• Click Load.
If the settings are loaded successfully, the status bar will display the
message, "Load from file successful".
Save the HART Settings
Follow this step to save the HART settings into a file buffer on the PC.
• Click Save.
If the settings are saved successfully, the message, "Save into file
successful" will be displayed in the status bar. The settings are saved to
the file, HART Block Parameter.hrt, by default.