Initialize the controller, Open the controller initialization dialog box, Switch controller into service mode – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 185
Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 185
Initialize the Controller
Use the Controller Initialization function to initialize the DataSite controller.
Open the Controller Initialization dialog box
Follow this step to open the Controller Initialization dialog box.
•
From the Operation menu, choose Controller Initialization.
The Controller Initialization dialog box appears.
Switch Controller into Service Mode
To initialize the controller, you must set the controller into the Service mode
first.
Follow these steps to set the controller into the Service mode.
1.
Power down the DataSite controller.
2.
Use a serial communication cable to connect one PC serial port with the
COM2 of the controller.
IMPORTANT
Only COM2 can be used.