Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 37)

Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 37
When the address of the master or slave register does not map to the signal,
the following error will appear.
Scan Time
Scan time refers to the read-write time interval of a scan block. You can use
the trigger scan function for COM port by programming the function block
COM_MSG in DataSite Workbench.
The following units of time are available. Note that ms represents
milliseconds, s seconds, m minutes, and h hours:
• 50 ms
• 500 ms
• 5 s
• 50 s
• 5 m
• 50 m
• 5 h
• 50 h