Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 136)

Publication 1758-UM002D-EN-P - October 2010
136 DataSite Flow Configuration Utility (DS FloConfig)
Set the Flow Rate Calculation Interval
The flow rate calculation interval is the interval at which flow rates are
calculated. You can set this interval according to your requirements. The
default value is 1 s.
Follow these steps to set the flow rate calculation interval.
1. Under Meter Parameter, enter the interval, in seconds, in the Interval
text box.
2. Click Download to apply the settings to the DataSite controller.
Select the Gas Flow Calculation Standard (AGA3/AGA7)
Follow these steps to select the gas flow calculation standard.
1. Under Meter Parameter, from the Standard pull-down menu, choose the
gas flow calculation standard according to on-site conditions.
– AGA3 for Orifice plate
– AGA7 for Turbine
2. Click Download to apply the settings to the DataSite controller.
IMPORTANT
After installing a meter, enable one meter first. Make sure
all the parameters have been set correctly and the flow rate
has been calculated correctly before you select the
Accumulate check box to start the accumulated flow
calculation every second.