Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 85)

Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 85
Set the Scan Time for the Online Debugging Mode
When you are debugging in the online mode, register data is refreshed at
regular intervals. You may change this interval according to your requirements.
Follow these steps to set the scan time.
1. Click Offline to go to the offline mode.
2. In the scan time box, enter a value for the desired time interval.
The default interval is 100 ms.
3. Click Online to go to the online mode.
Add a Register Group
Follow these steps to add a group of registers.
1. Click New Group.
The New Group box appears.
2. Enter a name for the new group.
3. Click OK.
The new group is added and listed in the Register Group box.
TIP
This value can only be set when you are in the offline
debugging mode.