Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 282)

Publication 1758-UM002D-EN-P - October 2010
282 Extension Modbus Protocol for DataSite Controllers (1758-FLO)
Command List
Extension Modbus protocol commands
Command
Number Description
1 Correct time
2 Set pass code
3 Set device name
4 Read device name
5 Disable/enable meter run
6 Read disable/enable setting of meter run
7 Set transaction (contract) time
8 Read transaction (contract) time
9 Set signal test
10 Read signal test settings and values
11 Disable/enable accumulation calculation of meter run
12 Read disable/enable setting of accumulation calculation of meter run
13 Set input parameters (AI/PI/Pulse)
14 Read input parameter settings (AI/PI/Pulse)
15 Set input parameter alarm range
16 Read input parameter alarm range
17 Set calculation input parameters
18 Read calculation input parameter settings
19 Set gas component parameters
20 Read gas component parameter settings
21 Reset accumulation
22 Read daily history recording
23 Read hourly history recording
24 Read alarm logs
25 Read new alarm logs
26 Read event logs
27 Read new event logs
28 Disable/enable the automatic component analysis instrument
29 Read the flag of the automatic component analysis instrument
30 Acknowledge alarms
31 Acknowledge events
32…355 Reserved