Load the hart settings, Save hart settings, Upload the hart settings from the controller – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 230: Download the hart settings to the controller
Publication 1758-UM002D-EN-P - October 2010
230 DataSite Flow Configuration Utility (DS FloConfig)
Load the HART Settings
This function enables you to load the HART settings previously saved in a file
buffer on the PC. This allows you to verify the settings while the DataSite
controller is offline.
Follow this step to load HART settings from the file.
•
Click Load.
If the settings are loaded successfully, the status bar will display the
message, "Load from file successful".
Save HART Settings
Follow this step to save the HART settings into a file buffer on the PC.
•
Click Save.
If the settings are saved successfully, the message, "Save successfully"
will be displayed in the status bar. The settings are saved to the file,
hart.hrt, by default.
Upload the HART Settings from the Controller
Follow this step to upload (read) HART Settings from the DataSite controller.
The controller needs to be online before you can upload the settings.
•
Click Upload.
Download the HART Settings to the Controller
Follow this step to download (write) HART Settings to the DataSite controller.
The controller needs to be online before you can download the settings.
•
Click Download.