Configure a time event, Upload event settings from the controller, Download event settings from the controller – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 81
Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 81
Configure a Time Event
Follow these steps to configure a time event.
1.
Select the Time Enable check box.
Time events are enabled.
2.
Select one of the options: Minute, Hour, Midday, Midnight.
The option you select determines how frequently the time event routine
will be executed.
•
Minute
At 0 seconds of every minute, a corresponding time break task is
executed in the application program written by users.
•
Hour
At 0 seconds, 0 minutes, hourly, a corresponding time break task is
executed in the application program written by users.
•
Midday
At 0 seconds, 0 minutes, 12 hours (noon), daily, a corresponding time
break task is executed in the application program written by users.
•
Midnight
At 0 seconds, 0 minutes, 0 hours (midnight), daily, a corresponding
time break task is executed in the application program written by
users.
Upload Event Settings from the Controller
Follow this step to upload (read) the event settings from the DataSite
controller. The controller needs to be online before you can upload the
settings.
•
Click Upload.
Download Event Settings from the Controller
Follow this step to download (write) event settings to the DataSite controller.
The controller needs to be online before you can download the settings.
•
Click Download.