Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 217)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 217
Return register +0, 2 = device specific status, 8-bit unsigned integer
+3 = Operational modes, 8-bit unsigned integer
+4, 5 = Analog outputs saturated, 24-bit unsigned integer
+6, 7 = Analog outputs fixed, 24-bit unsigned integer
+8, 13 = Device-specific status, 8-bit unsigned integer
Unit register Not used
HART state register +0 = state 0
+1 = state 1
Command 54
Purpose Read Transmitter Variable Information
Send register +0 = Code for transmitter variable to be zeroed, 8-bit unsigned
integer
Return register +0 = Return code for transmitter variable to be zeroed, 8-bit
unsigned integer
+1, 2 = Transmit variable sensor serial number, 24-bit unsigned
integer
+3 = Transmit variable limits units code, 8-bit unsigned integer
+4, 5 = Transmit variable upper limit (float point)
+6, 7 = Transmit variable lower limit (float point)
+8, 9 = Transmit variable damping value (seconds) (float point)
+10, 11 = Transmit variable minumum span (float point)
Unit register +0 = Transmit variable code, 8-bit unsigned integer
+1 = Transmit variable limits units code, 8-bit unsigned integer
HART state register +0 = state 0
+1 = state 1
Command 59
Purpose Write Number of Responses Preambles
Send register +0 = Number of preambles to be sent with the Response message
from the Slave to the Master, 8-bit unsigned integer, between 5
and 20
Return register Not used
Unit register Not used
HART state register +0 = state 0
+1 = state 1
Description of HART commands (Continued)