Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 220)

Publication 1758-UM002D-EN-P - October 2010
220 DataSite Flow Configuration Utility (DS FloConfig)
9
(Continued) •Invalid module type code—Selected module type code is not valid.
•Invalid flange type code—Selected flange type code is not valid.
•Frequency set point too high—Value entered for the frequency set point is too high.
•Density high limit too high—Value entered for the density high limit is too high.
•Selected totalizer cannot be reset—Totalizer selected for display and tertiary variable cannot be reset.
•Invalid page—Page requested is not supported.
•Invalid level units.
•Filter auto-adjust error.
•Maximum zeroing time is too large.
•DI too high—Value of the first density data is too high.
•Not in reference or sample mode.
•Invalid date.
•Invalid alarm relay HOLD default code.
•Frequency too high.
10 This bit can mean any of the following:
•Lower range value too low—Lower range value is less than the lower sensor limit.
•Applied process too low—Process applied to the field device is too low.
•Multidrop not supported—Field device does not support multidrop.
•Invalid range code—Range code selected is not valid.
•Calibration location not set to user—Before this command can be accepted, the calibration location must be set to User.
•Invalid configuration for special calibration—Configuration is not set properly for special calibration.
•Invalid liner material code—Liner material code selected is not valid.
•Frequency set point too low—Value entered for the frequency set point is too low.
•Density high limit too low—Value entered for the density high limit is too low.
•Invalid address—Address for this field device is not valid.
•Trim location not set to user—Before this command can be accepted, trim location must be set to User.
•Invalid body type code.
•Invalid volume units.
•Invalid density units.
•Maximum zeroing time is too small.
•DI too low—Value of the first density data is too low.
•Instrument in reference mode.
•Invalid analog output type code.
•Invalid automatic temperature compensation code.
•Invalid alarm relay configuration code.
•Frequency too low.
•Invalid low/high millivolt code
First byte when bit 7 = 0 (Command Response) (Continued)
Bit Description