Reset the communication parameters – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 189
Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 189
7.
To exit the Test Communication state, power the DataSite controller off
and on again.
Normal communication with the controller is resumed.
Reset the Communication Parameters
The following tables show the default values of the COM1, COM2 and
Ethernet communication parameters:
Default values of COM1, COM2 communication parameters
Parameter Name
Default Value
Station
1
Protocol
Modbus RTU
Master/Slave State
Slave
Duplex
Full
Baud rate (bps)
9600
Parity
None
Data bits
8 bits
Stop bits
1 bit
Port type
RS232
Timeout (10 ms)
100
Delay time (10 ms)
0
Default values of Ethernet communication parameters
Parameter Name
Default Value
IP
192.168.100.75
Mask
255.255.255.0
Gateway
192.168.100.1
Port
502