Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 247)

Publication 1758-UM002D-EN-P - October 2010
DataSite DNP3 Configuration Utility (DS DNP3) 247
9. Click Apply.
The new settings will take effect.
After downloading the DNP3 data, the DataSite controller will power
off and on again automatically. Wait for this power cycle to be
completed before resuming operation.
IMPORTANT
If NET0 or COM is configured as the communication
interface for DNP3, then they cannot be used by
DS FloConfig, DS Settings or Modbus Scan to
communicate with the DataSite controller.