Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 28)

Publication 1758-UM002D-EN-P - October 2010
28 DataSite Configuration Settings Utility (DS Settings)
Display the Default Settings
Follow this step to display default values.
• Click Default.
The message, "Default settings enabled." appears in the Information
box.
Serial Port Settings (Factory Default)
Parameter Name Parameter Value
Station 1
Master/Slave state Slave
Duplex Full
Baud rate (bps) 9600
Parity None
Data bits 8
Stop bits 1
Port type RS232
Timeout (10ms) 100
Delay time (10 ms) 0
Ethernet Port Settings (Factory Default)
Parameter Name Parameter Value
Ethernet card NET0
IP address 192.168.100.075
Basic port no. 502
Registration IP Address (Factory Default)
Parameter Name Parameter Value
Subnet mask 255.255.255.0
Default gateway 192.168.100.001
Power Enable Settings (Factory Default)
Parameter Name Parameter Value
COM1 (On-Off) Enable
LED (On-Off) Enable
Ethernet (On-Off) Enable