Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 184)

Publication 1758-UM002D-EN-P - October 2010
184 DataSite Flow Configuration Utility (DS FloConfig)
Complete the Calibration
Follow these steps to complete the calibration.
1. After the calibration process ends, click Finish.
The system will ask you if you want to stop using forced signal values.
2. If you want the flow calculation to return to using the live single inputs
from the sensors, click Yes.
If you want the controller to continue using the forced values, click No.
If you want to exit without stopping the forced signals, click Cancel.