Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 96)

Publication 1758-UM002D-EN-P - October 2010
96 DataSite Configuration Settings Utility (DS Settings)
All settings will be downloaded into the controller.
4. Click Run, and exit the local connection.
Test the Communication
Follow these steps to obtain the communication settings of the DataSite
controller, such as baud rate of the serial port, and the IP address of the
Ethernet port.
1. Set the controller into the Service mode.
2. Select the Communication Test check box.
3. Click Set.
All settings will be downloaded into the controller.