Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 320)

Publication 1758-UM002D-EN-P - October 2010
320 Extension Modbus Protocol for DataSite Controllers (1758-FLO)
There is no event code for command number 30.
Command Number 31: Acknowledge Events
Use command number 31 to acknowledge all the new events in the event log.
The controller will clear the flag for all the new events after receiving this
command.
There is no event code for command number 31.
49030…49034 — — Reserved
49035 — — Reserved
… — — Reserved
Return codes for command number 30
Return Code Description
00 OK
01 Pass code is incorrect
Other Invalid
Parameters for command number 31
Address Data Type Attribute Description
49025 u_short RW 31
49026 u_short R Return code
49027 — — Reserved
49028 u_int W Pass code for user
49030…49034 — — Reserved
49035 — — Reserved
… — — Reserved
Return codes for command number 31
Return Code Description
00 OK
100 Pass code is incorrect
Other Invalid
Parameters for command number 30 (Continued)
Address Data Type Attribute Description