Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 201)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 201
Edit a Scan Block
Follow these steps to edit a scan block.
1. In the Scan Config window, double-click the scan block you want to
edit.
The Edit dialog box appears.
2. Enter the values for the scan block parameters.
See the table
Scan block parameters and their descriptions on page 196 .
3. To save the changes and close the Edit dialog box, click OK.
To close the Edit dialog box without saving, click Cancel.