Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 291)

Publication 1758-UM002D-EN-P - October 2010
Extension Modbus Protocol for DataSite Controllers (1758-FLO) 291
There is no event code for command number 10.
Command Number 11: Disable/Enable the Accumulation
Calculation
Use command number 11 to disable or enable accumulation calculation for a
meter run.
1
Return codes for command number 10
Return Code Description
00 OK
01 Meter run is invalid
100 Pass code is wrong
Other Invalid
Parameters for command number 11
Address Data Type Attribute Description
49025 u_short RW 11
49026 u_short R Return code
49027 u_short W Meter run (0…7)
49028 u_int W Pass code for user
49030…49034 — — Reserved
49035 u_short W Whether accumulation calculation
is enabled.
Event codes for command number 11
Event Name Event Code
EVENT_START_ACCUMULATE 14
EVENT_STOP_ACCUMULATE 15
Return codes for command number 11
Return Code Description
00 OK
01 Meter run is invalid
02 The value for accumulation input is invalid
100 Pass code is incorrect
Other Invalid