Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 87)

Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 87
The Add Register dialog box appears.
3. In the Start_Addr text box, enter the address for the register.
4. In the Reg_Cnt text box, enter the number of registers you want to add.
If you are adding more than one register, the Start_Addr value will be
the address for the first register. Subsequent registers will have
consecutive addresses.
5. From the Type pull-down menu, select a register type from the
following options:
• Unsigned 16 bit unsigned int
• Signed 16 bit signed int
• Float Point 32 bit float number
• Hexadecimal Hexadecimal form
• Binary binary form
• ASCII ASCII code form
• BOOL BOOL type
If the selected register type does not map to Start_Addr, this error
message appears. Click OK and reselect the register type.
6. Click Add.
If the register address you entered is invalid, this error message appears.
Click OK and re-enter the register address.