Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 67)

Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 67
12
(Continued) •D2 too low—Value of the second density data is too low.
•Invalid command number.
•Invalid density units and calibration point.
•Flow rate factor too low.
13 This bit can mean any of the following:
•Upper and lower range values out of limits—Upper and lower range values are outside of their limits.
•Range and sensor type not entered—Before characterization, range and sensor type need to be entered.
•Invalid number of bytes—The Number of Bytes parameter received in this command is not valid.
•Invalid meter option—Meter option selected is not valid.
•Special sensor not available—Calibration for special sensor is not available.
•Invalid transfer function code.
•Invalid strapping point number.
•Invalid base mass flow units.
•Invalid base volume flow units.
•Invalid trim point number.
•Invalid cutoff type code.
•Invalid security code.
•Invalid alarm relay delay time code.
15 This bit can mean any of the following:
•Invalid analog output number code.
•Invalid level value.
•Invalid alarm relay number code.
•Invalid buffer number code.
16 Access restricted
28 Invalid range units code.
32 Device is busy
64 Command not implemented
(1) Bits 6…0 are decoded as an integer, and not bit-mapped.
First byte when bit 7 = 0 (Command Response) (Continued)
Bit Description