Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 41)

Publication 1758-UM002D-EN-P - October 2010
DataSite Configuration Settings Utility (DS Settings) 41
Edit a Scan Block
Follow these steps to edit a scan block.
1. In the Scan Settings dialog box, double-click the scan block you want to
edit.
The Edit dialog box appears.
2. Enter the values for the scan block parameters.
See the table
Scan block parameters and their descriptions on page 35 .
3. To save the changes and close the Edit dialog box, click OK.
To close the Edit dialog box without saving, click Cancel.