Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 94)

Publication 1758-UM002D-EN-P - October 2010
94 DataSite Configuration Settings Utility (DS Settings)
Initialize DataSite Workbench
Follow these steps to clear DataSite Workbench in the DataSite controller.
1. Set the controller into the Service mode.
2. Select the DS Workbench Initialization check box.
3. Click Set.
All settings will be downloaded into the controller.
4. Click Run, and exit the local connection.
Reset the Controller Communication Parameters
Follow these steps to reset the controller communication parameters to their
default values.
1. Set the controller into the Service mode.
2. Select the System Initialize check box.
3. Click Set.
All settings will be downloaded into the controller.
4. Click Run, and exit the local connection.