Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 195)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 195
Display System Information
Follow these steps to check the basic factory information of the DataSite
controller.
1. Set the controller into the Service mode.
2. Click Sys info.
Basic factory information on the DataSite controller appears in the
Information box.
3. Click Run.
4. Click Close and then exit the Service mode.
Clear Status Message
Follow this step to clear all the status messages in the Information box.
• Click Clear info.