Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 163)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 163
Enable an Alarm Configuration
Follow these steps to enable an alarm configuration.
1. In the Alarm Config dialog box, double-click the alarm configuration
you want to enable.
The Alarm Configuration dialog box appears.
2. Enter the values for Hi Limit, Lo Limit and Dead Band.
3. Select the Enable check box.
4. Click OK to save the configuration.
The configuration is displayed as ‘Enabled’.
5. Click Download.
The new settings are applied to the DataSite controller.